#1300T Reflective White Roof Coating

#1300T White Plastic is a liquid acrylic emulsion formulated to cure to a flexible waterproof membrane.  The cured product has excellent tensile, elongation, flexibility and recovery properties.  #1300T WHITE PLASTIC quality products for roofing and waterproofing are time tested since 1975.

PRODUCT USES

#1300T is the specified white reflective finish coat for the Recycled Rubber Roof System.

ADVANTAGES


#1300T cures dry and does not soften with the heat of the sun and does not become brittle.  The elastomeric properties provide elongation to move with the expansion and contraction on the roof.

SURFACE PREPARATION


The surface must be dry, sound, smooth and clean, free of dirt, oil, grease, asphalt that is not cured dry, or  any contaminate that would adversely affect adhesion, free of blisters and water ponding.  The roof surface must be properly sloped to drains and eaves.  Cants and tapered edges are to be sound and pre-formed to a 45º angle.  Do not apply over wet roof insulation.  If existing roof is not dry or sound, tear it off.  Remove all loose roofing from parapets before applying reinforcing fabric with #1300T.  Do not apply over asphalt based aluminum or silicone coatings without applying an oil based primer that will adhere to silicone coatings.

 

APPLICATION


#1300T White Plastic is applied at the rate of 100 sq. ft./gal for each coat.  Application is with nylon paint brush, paint roller or commercial airless spray equipment.  The reflective white finish coat may be tinted with universal colorant to pastel shades. 

PRECAUTIONS


Temperature and humidity affect the curing time.  Do not apply at temperature below 50ºF, or if the temperature will fall below 40ºF within 24 hours.  Do not apply if it will rain within 24 hours.  Protect the contents of this container from freezing.

CLEAN-UP


Tools and equipment may be cleaned with water immediately after use.  Do not thin this product.

 

 

 

Viscosity 2400 CPS
Thinning Thinning of products is not recommended.  When necessary use water.
Dry Time Temperature and humidity affect the curing time. Do not trap moisture between coats.  Do not apply below 50ºF.
Flash Point Not determined (aqueous system).
Weight/Gallon 10.4
#1300T #1300T is white as compared to off white #1300.  It is used as the top coat on roofing applications when a more reflective surface is desired.
U.S.D.A. Approved for walls and ceilings in food processing plants.
U.L. 790 Tested Class A and Class B. See U.L. Classified Building Materials Index.
Caution Keep out of reach of children.  Close container after each use.  Avoid prolonged contact with skin or breathing or spray mist.  Do not take internally.  Use adequate ventilation.
Packaging
Per Case

Approx. Wgt.
55 Gallon Single 610 lbs.
5 Gallon Single 55 lbs.
2 Gallon Single 44 lbs.

LIMITED WARRANTY
Specification Chemicals, Inc.  warrants this product which is designed to be used by experienced applicators in accordance with industry accepted work practices.  Since we have no control over the design or the workmanship of the installation, we make no warranties on the performance of the finished application.  We do warrant this product to be free of defects in material and workmanship for a period of five years.  Our sole liability shall be to supply a like quantity of non-defective product.  Specification Chemicals, Inc.  makes no other warranty of any kind, express or implied, in fact or in law, including without limitation, the warranty of fitness for a particular purpose, other than the limited warranty set forth above.